Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 54)

-52-

G0513 Series Bandsaws

Stacked Cuts

One of the benefits of a bandsaw is its ability to

cut multiple copies of a particular shape by stack-

ing a number of workpieces together. Before mak-

ing stacked cuts, ensure that both the table and

the blade are properly adjusted to 90°. Otherwise,

any error will be compounded.

To complete a stacked cut:

1. Align your pieces from top to bottom to

ensure that each piece has adequate scrap

to provide a clean, unhampered cut.

2. Secure all the pieces together in a manner

that will not interfere with the cutting. Hot

glue on the edges works well, as do brad

nails through the waste portion. (Be careful

not to cut into the brads or you may break the

blade!)

3. On the face of the top piece, lay out the

shape you intend to cut.

4. Make relief cuts perpendicular to the out-

line of your intended shape in areas where

changes in blade direction could strain the

woodgrain or cause the blade kerf to bind.

5. Cut the stack of pieces as though you were

cutting a single piece. Follow your layout line

with the blade kerf on the waste side of your

line, as shown in Figure 76.

Figure 76. Example of stack cutting.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 107 108

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 54