Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 24)

-22-

G0513 Series Bandsaws

Installing Fence (G0513, G0513P,

G0513ANV, G0513X2, & G0513X2F)

1. Attach the rear rail to the table with the

(2) M6-1 x 16 cap screws, as shown in

Figure 20.

2. Attach the front rail with the (2) M6-1 x 20 hex

bolts, 6mm lock washers, and 6mm flat wash-

ers, as shown in Figure 20.

3. Install an M8-1.25 hex nut on the fence

handle, then thread the handle into the fence

assembly, as shown in Figure 21. Tighten

the hex nut against the fence pivot block to

secure the handle.

Figure 21. Handle installed on fence assembly.

Hex

Nut

Pivot Block

4. Thread the M6-1 hex nut onto the rail pad,

then thread the rail pad into the rear of the

fence (see Figure 22).

Figure 22. Installed rail pad.

Rail Pad

Hex Nut

5. Pull the fence handle up and place the fence

assembly on the front rail (see Figure 23 for

an example photo).

Figure 23. Example photo of correctly installed

fence.

6. Push the fence handle down to lock the fence

assembly in place.

7. Adjust the rear rail pad until there is an even

gap between the bottom of the fence and the

table, then tighten the rail pad hex nut against

the fence.

Figure 20. Rail installation.

Rear Rail

Front Rail

x 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 107 108

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 24