Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 35)

G0513 Series Bandsaws

-33-

Before adjusting the blade guides, make

sure the blade is tracking properly (Page 25)

and that it is correctly tensioned (Page 30).

A. Support Bearing. Stops excessive back-

ward blade deflection from the pressure of

the advancing workpiece.

Note: The flat surface of the upper support

bearing faces the blade. The round edge of

the lower support bearing faces the blade.

B. Upper Support Bearing Shaft. Mounts the

support bearing behind the blade. When the

support bearing shaft cap screw is loose,

move this shaft by hand to adjust the upper

support bearing approximately 0.016" behind

the blade, then re-tighten the shaft cap screw

to secure the setting.

C. Support Bearing Shaft Cap Screw. When

loose, allows distance adjustment of the sup-

port bearing behind the blade.

D. Lower Support Bearing Adjustment Knob.

When the support bearing shaft cap screw is

loose, moves the support bearing toward or

away from the blade. Use this knob to adjust

the lower support bearing approximately

0.016" behind the blade, then re-tighten the

shaft cap screw to secure the setting.

Adjusting Blade

Guides

The blade guides provide side-to-side support

to keep the blade straight while cutting. These

guides are adjustable in two ways—forward-and-

back and side-to-side.

To keep the blade straight while cutting, the blade

guides must be as close to the sides of the blade

without exerting any clamping pressure. This dis-

tance is typically about 0.004".

To prevent damage to the blade teeth as the blade

deflects back while cutting, the guides must be

behind the teeth gullets the same amount as the

support bearing is behind the blade, which is typi-

cally about 0.016" (see Figure 41 on the previous

page for an illustration of this relationship).

Note: Models G0513, G0513P, and G0513ANV

use carbide discs as guides, while the remaining

models use ball bearings.

Important: Although the function and the distance

adjustment of the blade guides is the same for all

the G0513 Series Models, the guide controls are

not all the same. Use the set of instructions on

the following pages that is correct for your model

of bandsaw.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 35

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motorsägen Grizzly G0513P