Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 33)

G0513 Series Bandsaws

-31-

Deflection Method

The deflection method is more subjective than the

flutter method. Each blade deflects differently and

every user must determine what "moderate pres-

sure" means. The following are general guide-

lines for tensioning the blade with the deflection

method.

To tension the bandsaw blade:

1. DISCONNECT BANDSAW FROM POWER!

2. Make sure the blade is properly tracking as

instructed in the Initial Blade Tracking sec-

tion on Page 25.

3. Raise the guide post all the way, and move

the upper and lower blade guides away from

the blade.

4. Engage the blade tension quick-release lever

to apply tension to the blade.

Whenever changing a blade or adjusting

tension and tracking, the upper and lower

blade support bearings and blade guides

must be properly adjusted before perform-

ing cutting operations.

5. Using moderate pressure, push the center of

the blade sideways.

— If the blade deflects approximately

⁄4", it is

properly tensioned. Proceed to Step 6.

— If the blade deflects less than

⁄4" it is

over-tensioned. Turn the blade tensioning

handwheel counterclockwise two full turns

and repeat this step.

— If the blade deflects more than

⁄4", the

blade is under-tensioned. Apply tension to

the blade a small amount and repeat this

step until the blade is properly tensioned.

6. Re-adjust the blade guides as described in

Adjusting Blade Guides beginning on Page

33 for your model bandsaw.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 107 108

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 33