Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 30)

-28-

G0513 Series Bandsaws

3. Loosen the right strain relief on the junction

box, then feed the cord into the box with

enough slack in the wires to make the con-

nections.

4. Re-tighten the strain relief around the cord.

Tug on it to make sure the wires inside the

box will not move.

5. Connect the incoming ground wire to the

ground post, as shown in Figure 36.

6. Secure the two incoming hot wires to the

black and white wires from the bandsaw

with wire nuts, then wrap the nuts and wires

with electrical tape to make sure they will not

come loose.

7. Re-attach the junction box cover.

Power Supply Junction Box

R

S

E

Ground

From

Power Supply

To

Bandsaw

Strain

Relief

Ground

Figure 36. Incoming power cord connections.

Once the assembly is complete, test run your

machine to make sure it runs properly and is

ready for regular operation.

The test run consists of verifying the following: 1)

The motor powers up and runs correctly, and 2)

the safety disabling mechanism works correctly.

If, during the test run, you cannot easily locate

the source of an unusual noise or vibration, stop

using the machine immediately, then review

Troubleshooting on Page 57.

If you still cannot remedy a problem, contact our

Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1. Make sure that you have successfully com-

pleted the Initial Blade Tracking procedure

on Page 25 before continuing.

2. Make sure you have read the safety instruc-

tions at the beginning of the manual and that

the machine is setup properly.

3. Make sure all tools and objects used during

setup are cleared away from the machine.

4. Connect the machine to the power source.

5. Test the operation of the machine to verify

that it starts and operates correctly.

G0513, G0513P, G0513ANV, & G0513X2

Only

a. Verify that the machine is operating cor-

rectly by pressing the power button.

— When operating correctly, the

machine runs smoothly with little or

no vibration or rubbing noises.

— Investigate and correct strange or

unusual noises or vibrations before

operating the machine further. Always

disconnect the machine from power

when investigating or correcting

potential problems.

Test Run

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare