Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 53)

G0513 Series Bandsaws

-51-

To resaw a workpiece:

1. Verify that the bandsaw is setup properly and

that the table is perpendicular to the blade.

2. Use the widest blade your bandsaw will

accept.

Note: The blade must also be sharp and

clean.

3. Install the resaw fence, set it to the desired

width of cut, and lock it in place.

Note: When resawing thin workpieces, set up

the resaw fence in the alternate position, as

shown in Figure 75, and make sure to use a

push stick.

4. Support the ends of the board if necessary.

5. Turn the bandsaw ON.

6. Using push paddles and a push stick, keep

pressure against the fence and table, and

slowly feed the workpiece into the moving

blade until the blade is completely through

the workpiece.

The fence scale will NOT be accurate when

using the resaw fence.

Cutting Curves

When cutting curves, simultaneously feed and

turn the stock carefully so that the blade follows

the layout line without twisting. If a curve is so

abrupt that it is necessary to repeatedly back up

and cut a new kerf, use either a narrower blade

or a blade with more TPI (teeth per inch), or make

more relief cuts.

Always make short cuts first, then proceed to

the longer cuts. Relief cuts will also reduce the

chance that the blade will be pinched or twisted.

Relief cuts are cuts made through the waste

portion of the workpiece and are stopped at the

layout line. As you cut along the layout line, waste

wood is released from the workpiece, alleviating

any pressure on the back of the blade. Relief cuts

also make backing the workpiece out easier, if

needed.

NOTICE

The list below displays blade widths and

the corresponding minimum radii for those

blade widths.

Width Radius

⁄8" ....................................

⁄8"

⁄16" ...................................

⁄8"

⁄4'' ....................................

⁄8''

⁄8'' .................................... 1

⁄4''

⁄2'' .................................... 2

⁄2''

⁄8'' .................................... 3

⁄4''

⁄4'' .................................... 5

⁄2''

Figure 75. Resaw fence installed in the alternate

position.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 53

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motorsägen Grizzly G0513P