Grizzly G0513P Bedienungsanleitung PDF herunterladen (Seite 51)

G0513 Series Bandsaws

-49-

Blade Speed

The blade speed can be adjusted to 1700 or 3500

FPM. Speed adjustments are made by moving the

V-belt position on the motor and wheel pulleys.

Most woodcutting can be performed successfully

at the higher blade speeds. Slower blade speeds

generally produce better results when cutting

hardwoods, intricate curves, or when an excep-

tionally smooth cut is desired.

Use the chart below as a general guide to

blade speed:

Type of Cutting Operation

Blade Speed

(FPM)

Most Species of Wood 3500

Super Dense Hardwood 1700

Fast/Average Feed Rate 3500

Requires Slow Feed Rate 1700

Rough Edges Acceptable 3500

Requires Smooth Edges 1700

Quick, Production Cuts 3500

Detailed, Intricate Cuts 1700

To adjust the blade speed:

1. DISCONNECT BANDSAW FROM POWER!

2. Loosen the motor mount cap screws shown

in Figure 70, and rotate the motor to loosen

the V-belt.

Figure 70. Motor mount cap screws.

3. Refer to Figure 71 to locate the correct V-belt

position for the desired blade speed and

move the V-belt to the indicated pulleys.

3500 FPM

1700 FPM

BANDSAW

WHEEL

MOTOR

WHEEL

Figure 71. V-belt speeds.

Bandsaw

Wheel

⁄4"

Deflection

Motor

Wheel

Figure 72. V-belt deflection.

4. Rotate the motor to tension the V-belt, then

tighten the motor mount cap screws.

5. Check the V-belt tension by applying mod-

erate pressure between the pulleys (see

Figure 72). If deflection is not approximately

⁄4", re-tension the V-belt until it is.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 107 108

Kommentare zu diesen Handbüchern

Keine Kommentare

Grizzly G0513P Bedienungsanleitung Seite 51

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motorsägen Grizzly G0513P