Grizzly G0592 Bedienungsanleitung PDF herunterladen (Seite 21)

G0592 Metal Cutting Bandsaw

-19-

The adjustments listed below have been per-

formed at the factory. However, because of the

many variables involved with shipping, we recom

mend that you at least verify the following adjust

ments to ensure accurate cutting results.

Step-by-step instructions on verifying these adjust-

ments can be found in SECTION 7: SERVICE

ADJUSTMENTS.

Factory adjustments that should be verified:

1. Blade Tracking (Page 35).

2. Blade Guide Bearings (Page 36).

Recommended

Adjustments

Starting the machine:

1. Read the entire instruction manual.

2. Make sure all tools and foreign objects have

been removed from the m

achine.

3. Put on safety glasses and secure loose

clothing o

r long hair.

4. Connect the bandsaw to power.

5. Raise the bandsaw and close the feed con-

trol knob to keep the saw in place

Projectiles thrown from

the machine could cause

serious eye injury. Wear

safety glasses during

assembly and operation.

Test Run

6. Start the bandsaw while keeping your finger

near the EMERGENCY S

TOP/OFF button

(Figure 14) at all times during the test run.

The bandsaw should run smoothly with little

or no

vibration.

Note: If the EMERGENCY STOP/OFF button

is pressed, it needs to be twisted until it pops

out or the bandsaw will not start

— If you suspect any problems, immediately

stop the bandsaw and correct before con

tinuing.

—If you need any help with your bandsaw

call our Tech Support at (570) 546-9663.

Figure 14. Control panel.

E-STOP/OFF Button

Feed control knob

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Grizzly G0592 Bedienungsanleitung Seite 21

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Motorsägen Grizzly G0592